Cessna 170 · Variant · CAA approval Sept. 28, 1950

Cessna 170B

The last and most-built 170: slotted flaps, a revised horizontal tail and a flap limiter on the 170A’s metal wing. Limits and serials from FAA data sheet A-799.

None listed yetAll Cessna 170 models
Engine
C145-2 / -2H145 hp at 2,700 rpm
Max weight
2,200 lblandplane, normal
Serials
See table609, 19401, 20267–20999 and 25000–27169; 2,905 by serial no.
Approved
Sept. 28, 1950landplane (CAA)
Cessna 170B taildragger on a paved ramp
Photo: Gary ToddPublic domain
Overview

What changed in the 170B

The FAA data sheet describes the 170B as the same as the 170A except for slotted flaps, a revised horizontal tail, revised flap and aileron control systems, a flap limiter and numerous other minor changes.1

The landplane was approved on September 28, 1950 and the seaplane on October 29, 1951.1 The 170B was certified to Civil Air Regulations Part 3 dated November 1, 1949, a newer basis than the 170 and 170A.1

Flap settings are 0°, 10°, 20°, 30° and 40°; the data sheet notes that serials 20267 through 26504 were delivered without the 10° notch.1 Engine, weights, fuel (42 gal total, 37 usable) and landplane airspeed limits carry over from the 170A.1 With 2,905 serial numbers listed, the 170B accounts for more than half of all 170 serials on the data sheet.1

170B at a glance

  • Type certificateA-799
  • ApprovedLandplane Sept. 28, 1950 · seaplane Oct. 29, 1951
  • Seats4 normal · 2 utility
  • EngineContinental C145-2 or -2H, 145 hp
  • Max weight2,200 lb land · 2,106 lb sea (normal)
  • Fuel42 gal total · 37 usable
  • Wing flapsSlotted, 0–40°
  • Serial numbers609, 19401, 20267–20999, 25000–27169

Sources:1

Specifications

170B type-certificate data

The FAA data sheet does not give dimensions or performance for the 170B, so none are shown.

Powerplant

EngineContinental C145-2 or C145-2H1
Rating145 hp at 2,700 rpm1
Fuel grade80 octane minimum1
Optional engineContinental O-300-A, same limits (item 112)1

Weights & capacities

Landplane, normal2,200 lb1
Landplane, utility1,900 lb1
Seaplane, normal2,106 lb1
Seaplane, utility1,975 lb1
Seats41
Baggage120 lb1
Fuel42 gal total, 37 usable (two 21 gal tanks)1
Oil2 gal1

Certification & flaps

LandplaneApproved Sept. 28, 19501
SeaplaneApproved Oct. 29, 19511
BasisCAR Part 3 (Nov. 1, 1949), amendments 3-1 and 3-21
Flap notches0°, 10°, 20°, 30°, 40°1
FAA limits

Airspeed limits & 170B vs 170A

Landplane values from FAA data sheet A-799, section III (“True Ind.” mph, knots in brackets).

VNE
139
kt
Never exceed (160 mph)
VNO
122
kt
Max structural cruising (140 mph)
VA
100
kt
Maneuvering (115 mph)
VFE
87
kt
Flaps extended (100 mph)

Seaplane limits are the same as the 170A seaplane: never exceed 140 mph (122 kt), maximum structural cruising 110 mph (96 kt), flaps extended 100 mph (87 kt).1

Item170A170B
Approved (landplane)Dec. 15, 1948Sept. 28, 1950
WingSingle-strut all-metalAll-metal, slotted flaps
Fuel (total · usable)42 gal · 37 gal42 gal · 37 gal
TanksTwo 21 galTwo 21 gal
Wing flaps50°0–40° in notches
VFE100 mph (87 kt)100 mph (87 kt)
Seaplane approvalJune 28, 1949Oct. 29, 1951
Serials18730–20266 (exc. 19401)609, 19401, 20267–20999, 25000–27169
Built (by serial no.)1,5362,905

Limits shown are type-certificate values. Always fly by the airplane’s own POH/AFM and placards.

Serial numbers

170B serial numbers and the flap notch

Parts catalogs and service bulletins use serial-number effectivity. Flying411 tags parts to these ranges so a buyer sees what fits their airplane.

Serial rangeWhat it meansSource
609Listed as a 170B.FAA data sheet A-799
19401Listed as a 170B (inside the 170A block).FAA data sheet A-799
20267 – 20999First 170B block; delivered without the 10° flap notch.FAA data sheet A-799
25000 – 26504Delivered without the 10° flap notch.FAA data sheet A-799
26505 – 27169Remaining 170B serials, delivered with the full notch set.FAA data sheet A-799

Counting every listed serial gives 2,905 airplanes: 1 + 1 + 733 + 2,170.1

Market analysis

Cessna 170B prices on the market

No Cessna 170B listings on Flying411 right now.

Parts

Parts for the Cessna 170B

No parts listed for the Cessna 170B on Flying411 right now.

FAQ

Cessna 170B questions

What changed on the 170B?

Slotted flaps, a revised horizontal tail, revised flap and aileron control systems, a flap limiter and other minor changes, per the FAA data sheet. The wing and fuel system carry over from the 170A.

Does every 170B have a 10° flap notch?

No. The data sheet says serials 20267 through 26504 were delivered without the 10° notch. The full set is 0°, 10°, 20°, 30° and 40°.

How many 170Bs were built?

The data sheet lists 2,905 170B serial numbers: 609, 19401, 20267 to 20999 and 25000 to 27169.

When was the 170B approved on floats?

The 170B seaplane was approved on October 29, 1951, a little over a year after the landplane (September 28, 1950).

What is the 170B’s maximum weight?

2,200 lb as a landplane in the normal category, 1,900 lb utility, and 2,106 lb as a seaplane in the normal category.

Buying or selling a 170B?

Browse 170B listings, find parts by serial range and ATA chapter, or list your aircraft on Flying411.

None listed yetCreate a listing
Sources

Where these facts come from

Specifications, limits, approval dates and serial numbers come from FAA type certificate data sheets. “Built (by serial no.)” counts the serial numbers the FAA data sheet lists; it is not an official production total. Marketing names and history appear only where a primary source or two independent published sources agree; anything else is labeled unconfirmed. Numbers in brackets point to the list below.

  1. FAA Type Certificate Data Sheet A-799, Revision 55 (July 29, 2015) — Cessna 170, 170A, 170B: engines, airspeed limits, weights, fuel, serial numbers, approval dates. drs.faa.gov

Content reviewed Nov. 15, 2026. Always use the aircraft’s own POH/AFM, logbooks and current FAA records for operational or airworthiness decisions.